Operates in any of the sweep modes described in Sweep Modes, except Frequency. Repeats a DC operating point calculation for the range of circuit parameters defined by the sweep mode.
In this topic:
|Start value, Stop value||Defines sweep range stop and start values.|
|Points per decade, Number of points||Defines sweep range. The number of points of the sweep is defined per decade for a decade sweep. For a linear sweep you must enter the total number of points.|
|Device/Parameter/Model Name||The device name for a device sweep, parameter name for a parameter sweep or the model name for a model parameter sweep may be entered here. It may also be entered in the sweep mode dialog opened by pressing Define....|
|Define...||Sets up desired sweep mode. See Setting up a Swept Analysis.|
See Multi-step Analyses.
Using the example circuit (used previously): The following is the result of a DC sweep of V3 with restail set to 1K. Analysis parameters were as follows:
Sweep mode: Device, V3
Sweep range: -0.1 to 0.1, linear sweep with 50 points.
|◄ Sweep Modes||AC Sweep ▶|